how to install the pen-shaped tea handle:
cut the fine bamboo branches into 30 cm lengths, arrange them neatly and clip them into the randomly prepared tea plywood. note that the bamboo branches on the side of the pot are thicker than the bamboo branches on the pot heart. cut the lower end of the tea into the outer length and the length is 1 cm. then, without pressing the joystick, put the tea handle on the lower shaft of the machine, loosen the adjusting screw on the shaft, and let the tea handle the lowest end. the bottom of the pot is about 1 cm. after adjusting the distance, tighten the screws on the tea handle and the screws on the shaft.
operation method:
(1) insert the power plug of the machine into the 220v socket;
(2), press the heating switch, adjust the temperature regulator to 200 ° c (depending on the dry humidity of the tea after killing), at this time the "on" indicator of the regulator is on, when the "off" indicator of the regulator is on, press the lower motor switch is placed into the tea after the greening from the machine inlet. after a few minutes, press the joystick. after the tea leaves are thinned, open the discharge port and the tea leaves are automatically released. after the tea leaves in the pot are cleaned, insert the discharge door.
the main technical parameters
model voltage （v） motor power（kw） heating power（kw） fan power（kw） productivity（kg/h） dimensions（length, width and heightmm）
6ccgk-60 220 0.75 3.6 0.04 13 1050×750×1250
6ccgk-70 220 0.75 4.8 0.04 15 1050×820×1250
6ccgk-80 220 0.75 7 0.04 20 930×900×15706
ccgk-100 220 1.1 9 0.18 25 1100×1000×1600
6ccgk-120 380 1.1 11.5 0.18 40 1300×1200×1600